How To Do A Oil Change On 2015 Kia Soul 2.0

Kia Soul Engine Oil Change Guide
How to change the motor oil & supplant the filter on a 1st generation 2012-2013 Kia Soul with the Nu 2.0L I4 engine.

2013 Soul Nu 2.0L I4
Spin Off Oil Filler Cap
Pull Out Oil Level Dipstick This automotive maintenance tutorial was specifically written to assistance owners of the 2012 and 2013 Kia Soul with the Hyundai Nu ii.0 liter inline four cylinder engine in changing the motor oil and replacing the canister style oil filter.

Owners of other Hyundai or Kia vehicles equipped with the Nu ane.8L or two.0L engines such as the Elantra, Tucson, i30, i40, Optima Hybrid, K5 and the new 2014 Kia Soul may also notice these DIY instructions to be helpful.

The steps should be similar for the 2010-2011 Soul with the 1.6L Gamma or 2.0L Beta Ii engines and the 2012-2013 Soul with the one.6L Gamma GDI or Diesel fuel motors.

The tools needed to complete this process include a floor jack, ii jack stands (or automotive ramps), a 17mm socket with a three/8" or 1/2" drive ratchet, a used oil catch container, a new oil filter, an automotive funnel and 5 quarts of new SAE 5W-20 oil.

The 1st generation 2009 (Korea, Japan, Prc, etc), 2010-2013 (Due north America) and the new 2nd generation 2014 Kia Soul with whatsoever of the i.6L or two.0L I4 engines all apply the same oil filters.

A few compatible replacement canister oil filters with their function numbers are every bit follows: Mobil 1 M1-104, K&Due north PS-1004, Fram PH9688, Purolator PL14459, Imperial Purple 10-2808, Mahle OC 707, Pennzoil HPZ-37, Hastings LF565, Pennzoil PZ-37, Bosch 3312, Wix 51334, Mann-Filter ML 1002, ACDelco PF1127, Ecogard X4612 and Brook Arnley 041-8151.

Raise Front of Vehicle
Oil Pan & Canister Filter
Black Metal Oil Drain Bolt The first steps are to warm upwardly the engine for a few minutes, park the vehicle on a level surface and so shut off the engine.

Warming up the engine will help append whatsoever contaminants within the old oil and also allow it to bleed out more quickly.

So open the hood, twist off the oil filler cap in the counter clockwise management and pull the yellow handled dipstick out a few inches.

Removing the oil filler cap and pulling up the dipstick volition aid preclude a vacuum from forming and too allow the old oil to drain out more quickly.

Raise the front of the vehicle with the floor jack and securely back up information technology with the two jack stands.

Y'all may also choose to bulldoze the car up on automotive service ramps.

Slide nether the front passenger side of the vehicle with a 17mm socket, a ratcheting wrench and a used oil catch basin.

One-time Canister Oil Filter
Loosen Counter Clockwise
Drain Out Former Oil Locate the black metallic oil drain bolt at the rear edge of the black metal oil pan.

The oil filter is located just in front of the oil pan.

Place the used oil grab container simply below the oil drain bolt.

Loosen the oil bleed plug past turning information technology counter clockwise with a 17mm socket and ratcheting wrench.

Supercede 17mm Drain Plug
Spin Off Quondam Oil Filter
Move Basin Forward Let the old oil to drain out for at least a few minutes or until the flow slows to an occasional baste.

If your vehicle's bleed plug is equipped with a crush washer, it should be replaced at every oil change.

Make clean the area effectually the oil drain hole and spin in the drain bolt a few turns by hand to prevent information technology from becoming cantankerous threaded.

Tighten the oil drain bolt in the clockwise direction with the 17mm socket and ratcheting wrench to just past hand tight or about 25 ft-lbs of torque.

Slide the used oil catch container forwards to just below the old oil filter.

Spin off the sometime oil filter in the counter clockwise direction by paw or utilize an oil filter wrench such as the Lisle # 63600.

Allow the onetime oil to drain out from the oil filter receptacle for a few minutes.

Dip Finger In New Oil
Lubricate Rubber O-Band
Spin On New Oil Filter Make certain that the safety o-ring gasket from the old oil filter is not however attached to the engine.

I recommend buying the Mobil i M1-104 oil filter since it has excellent reviews on Amazon.

Dip your pinky finger in to some new SAE 5W-twenty oil and lubricate the rubber o-ring gasket on the new oil filter.

Lubricating the gasket will help the oil filter to form a better seal, preclude oil leaks and make it easier to remove during the next oil change.

Clean the area around the oil filter receptacle and spin on the new filter in the clockwise direction to most ane/4 to ane/three turn past hand tight.

Do not over tighten the new oil filter and do not use an oil filter wrench to tighten information technology. Over tightening the oil filter may damage the o-ring gasket and pb to oil leaks.

Double check that the oil bleed commodities and new oil filter are tight earlier moving on to the next steps.

Lower the vehicle from the jack stands using the floor jack.

Lower Vehicle
Pour In New 5W-xx Oil
Supplant Oil Filler Cap The oil capacity of the 2012, 2013 & 2014 Kia Soul with the Hyundai Nu 2.0L I4 engine for an oil change with a filter replacement is 4.23 U.S. quarts (iv.0 liters).

(The oil capacity for the 2012-2013 Soul with the 1.6L Gamma GDI for an oil modify with filter replacement is 3.49 U.S. qts. or 3.3L.)

Insert an automotive funnel in to the oil filler pigsty and pour in only about three 3/4 to 4 quarts of new SAE 5W-xx oil.

It is far better to accept slightly less oil than necessary in an engine than to overfill it. Running an engine that has been overfilled with oil can lead to damaged seals, gaskets or other components.

Check Dipstick Oil Level
Replace Oil Dipstick
Oil Change Complete Replace the oil filler cap, push downwards the dipstick, run the engine for a few minutes, shut it off and allow the oil to drain back downwards to the pan for at to the lowest degree five-10 minutes.

Pull out the dipstick, wipe it clean, re-insert it, pull information technology out again and check the oil level.

If necessary, slowly pour in more than oil and repeatedly bank check the level on the dipstick until it reaches simply at or below the superlative of the cross hatched expanse at the end of the dipstick.

You may not need to cascade in the entire 4.23 U.S. quarts of new oil depending on how long you allowed the one-time oil to bleed out.

Brand sure the oil filler cap is securely in place and replace the dipstick.

Don't forget to tape the oil change in your vehicle's service records.

For more, check out my other Kia Soul DIY Maintenance Guides.